Please select a stone
Please enter your workshop sizes
Measure the length (mm) and width (mm) of each worktop piece, breakfast bar and island unit and input them individually into the boxes.
Please note All lengths over 3 metres will be jointed.The positions of the joints will be agreed with the client at the time of templating.
All Worktops come with a complimentary chopping board in the same granite as your worktops
Please enter your upstand sizes
Upstands are used behind the worktops, made from the same stone as the worktops but in 20mm thickness. Upstands are usually 100mm high, but other heights can be specified.
Splashbacks are stone panels used behind hobs, ranges and sinks. Splashbacks can also be fitted from the top of the worktops to underside of the wall units.
The edges of the worktops that are visible require polishing, a number of different profiles can be applied to these edges, ranging from Single Pencil Arris to Full Bullnose
Select Edging from Drop Down List Below
Enter Total Length to be Polished in mm
On Peninsular or Island Units you can choose to have curved, (radiused), ends. You can also choose to have the corners of your worktops rounded instead of squared off.
Enter Number of Radius Cuts
Enter Number of Rounded Corners
These are visible cut outs for under mounted, butler sinks etc that require the inner exposed edges to be polished
Enter Number of Polished Cutouts
These are the cutouts for taps and switch holes.
Enter Number of Tap Holes
These are straight grooves channelled into the worktop at the side of the sink which act as a draining board. These are normally supplied as a set of five grooves.
Enter Number of Sets of Groves (1 Set = 5 Grooves)
These are the cutouts with unfinished inner edges that are not visible for surface (over) mounted sinks, hobs etc
Enter Number of Unpolished Cutouts
A comprehensive care kit containing all you need to care for and maintain your worktops in beautiful condition.
Enter Number of Care Kits
Please enter your details and submit your quote.
